Honda Grom Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
998 Posts
Discussion Starter · #1 ·
I went at 10am to Evolution Motorcycles in Santa Clara and did my Grom dyno baseline run. Before I went to the shop I checked my tire pressure this morning and both F/R was at 19 lb so I filled it up to 29 lbs. I checked and cleaned/oiled the chain.

My Grom shows 1,500 miles on the odm. We ran 3 passes on the mustang dyno unit and all runs showed 8.5-9 hp with eng torque at 7ft-lbs at 5.6Krpm

I have the print out and also a short video of the run. RED line is the HP read from the left side of the print out and BLUE line is Torque on the right side of paper.

This image has been resized. Click this bar to view the full image. The original image is sized 640x426.

This image has been resized. Click this bar to view the full image. The original image is sized 640x426.

click in pic to run the video, temp in San Jose at 10am time frame was 62%,humidity 55%
 

·
Registered
Joined
·
178 Posts
I'm just running a Tyga full system and a K&N on the intake.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top