[hrcnick11]

I can look them up for you!

Not impressed with the centrifugal filter at all. Looks like a flywheel to me.

 

[Big Chris]

where can i tap the oil feed line and return on the engine

 

[hrcnick11]

This is a good question, normally done at the filter cover on my 250x and 150r. but this has no filter so I will keep looking for you.

 

[Big Chris]

case might have to be drilled out

 

[hrcnick11]

looking at the oil flow diagram now and it looks like the clutch cover has a some passageways in it going to the centrifugal filter that comes from the pump and goes into the crank from there. The centrifugal filter is on the end of the crank and is open on the end so I assume the flow comes from the cover.

 

[Big Chris]

anyway you can scan that for me? trying to figure out oil cooler and other needs

 

[Big Chris]

Still waiting on those scans if you can please

 

[peteyturbo]

I need range and resistance of iat sensor!

Sent from Motorcycle.com Free App

 

[engicedave]

In the headlight wiring, what's high/low/ground?

I am looking for a key switched hot and ground wire for the USB port install.

Thank you

 

[mad8vskillz]

In the headlight wiring, what's high/low/ground?

I am looking for a key switched hot and ground wire for the USB port install.

Thank you

use the frame as ground. but you do need the key switched hot.

 

[hrcnick11]

anyway you can scan that for me? trying to figure out oil cooler and other needs

Pretty sure that breaks copyright laws either way I'm not doing it.

 

[Big Chris]

WOW thats fine

 

[tyler500e]

What are the torque specs for the front and rear axles?

 

[engicedave]

How many muffler bearings are there?

 

[hrcnick11]

40 lbf-ft front
44 lbf-ft rear

 

[Honda_Grom]

On oil dipstick, is it specific to not thread in checking?

 

[hrcnick11]

Do not thread to check oil. That is in the user manual.

 

[chye]

Scan it!

 

[hrcnick11]

It will not help anyway it's a flow diagram does not show the actual motor parts or where the actual oil is in the engine.