Honda Grom Forums banner
1 - 10 of 10 Posts

· Registered
Joined
·
5 Posts
Did you drill the bars so the pin on the controls wont slide?

There are set pins in both the blinker housing and throttle tube housing.. I ground them off when I put my fat bars on and had to use a layer of tape to get them not to twist. Looking back maybe I should have drilled it.
 

· Registered
Joined
·
218 Posts
Discussion Starter · #10 ·
The bars feel good, they are a little low but ill get used to it. I just starting looking into rearsets, were moving and shipping the bikes to St Thomas, USVI and its nothing but turns down on that island so i may need some stickier tires too
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top